search

ohmbase / mix-g1-3dprinter

STL files for Mix G1 printer
0 stars 0 forks source link

Occasionally extruder leaves printing area #13

Open ghost opened 9 years ago

ghost commented 9 years ago

It is printing just fine, then suddenly goes well the hell out in the direction where there is no endstops.

1) verify slic3r isn't breaking (short term) 2) put end stops on( longer term)

ghost commented 9 years ago

this seems to be when one of the cables on the x or y axis end stop gets disconnected.

ghost commented 9 years ago

that's what it was