review

[jcolomb]

• check index_BOM.html, look for duplicates (different names going to the same description), change it in the doc to de-duplicate it.

• Predrill of Top plexiglass plates: distances are different from earlier version: need a check. + give distance in absolute value too (in the text).

• check value for Predrill long sides and make a drawing.

• side_plates.jpg is wrong, rewrite description to fit the other one (Predrill short sides)

• explain difference in hole size (2,3,5,8 ?)

• Airtable part 3: Glueing and screwing: add photo of result

• tell which side should be the holes (the one 10 mm from the border)

• [Connect the air table box and the U-formation framework with two M5x12mm screws from the inside of the air box in each nut: Does it need to be air tight ?

• there are 4 holes, but you speak of 2 nuts ??

• Glue bottom plate gets 2 entries ?

• Step 3: Attach a second frame circle: photo does not have the extra horizontal sturt used for the camera. Is it needed for stability? If not, I would put it in the camera fixing chapter.

Incoming air and pressure control : NOT WORKING

• would it be better to predrill ?
• in any case drilling should be done before gluing the bottom part !!

pixie camera: 3d files should have holes. or give alternative using any piece of plastic found around ?

Construction of the linear actuator front: should it not be part of reward system ?

sometimes, things may be simplified, see https://github.com/open-make/airtrack-doc-website/pull/12/commits/d7cd7c13dc2bf3aee7a2a5502b6622d241fe9b65

[jcolomb]

ask workshop about screws inside: air tight, do not get loose

• balls in large setup: what are they
• review löcher für air system.