opendata-stuttgart / sensors-software

sourcecode for reading sensor data
577 stars 313 forks source link

dust sensor when it rains #923

Open kamomil opened 3 years ago

kamomil commented 3 years ago

Hi, I build that dust sensor according to these instructions: https://sensor.community/en/sensors/airrohr/ In the instructions it is shown that the dust sensor and the ESP8266 should stick out from the pipe. But what happen in case of rain? then those parts are note protected

ricki-z commented 3 years ago

Please read the complete instructions! After connecting the 2 pipe parts the SDS011 and the ESP8266 should be in the upper part of the "∩". Only a very short part of thin pipe (going to the SDS011) should stick out. The BME280 should be placed on this thin pipe inside the larger pipe but as near on the opening as possible.

kamomil commented 3 years ago

oh, I was not even aware that two pipes are needed. I thought there is only one. So the pipes are not identical? I bought the parts separately (not as a kit). The pipe I have is currently as listed in the instructions: 'DN 75 87°'.

ricki-z commented 3 years ago

The 2 pipe parts are identical. So the second one is also a 'DN 75 87°'. One end of the pipes is slightly larger than the other so that you can plug in the smaller end of the other part.

ClemensGruber commented 2 years ago

Have a loot at e.g.: https://www.byteyourlife.com/wp-content/uploads/2017/04/Feinstaub_Luftdaten_selber_messen_Sensor-1200x640.jpg