on a fresh installation openhab webserver does not start.
if I want to set up OH4 in openhabian-config I got the following error: There was an error or interruption during the execution of: "30 | System Settings"
when I start the SSH on the welcome tesxt i see this error: "sed: can't read /var/lib/openhab/etc/version.properties: No such file or directory" see the attached printscreen
I had the similar issue before but as I remember after 02 and/or 03 of openhabian-config I could solve it and the system had been running for months. Than suddenly the web UI disappeared. I was also not able to connect using Samba to save a backup and couple of days later the system crashed. It seemd any network error as I was not able to ping its IP address and it did not connect neither on WIFI nor ethernet. Than I tried to reinstall the entire OH4 using a new SD card.
Before installation I changed the hostname to rpi
During installation I did not get any error.
If I check /opt/openhabian-install-successfull looks OK
After installation I restarted the rPi using SSH.
Than I changed the config file with ipv6=disable and restarted again but it did not helped
System information:
OS: Raspberry Pi OS at Rpi 3B
HW: you are running on (Raspberry Pi, amd64).
Connection: Ethernet
'uname -m' returns with armv7l
os-release.txt
I have run another OH4 instance on the same network on a Rpi4
Issue information:
I had the similar issue before but as I remember after 02 and/or 03 of openhabian-config I could solve it and the system had been running for months. Than suddenly the web UI disappeared. I was also not able to connect using Samba to save a backup and couple of days later the system crashed. It seemd any network error as I was not able to ping its IP address and it did not connect neither on WIFI nor ethernet. Than I tried to reinstall the entire OH4 using a new SD card.
Debug information:
first-boot.txt openhabian.txt
Before installation I changed the hostname to rpi During installation I did not get any error. If I check /opt/openhabian-install-successfull looks OK After installation I restarted the rPi using SSH. Than I changed the config file with ipv6=disable and restarted again but it did not helped
System information:
OS: Raspberry Pi OS at Rpi 3B HW: you are running on (Raspberry Pi, amd64). Connection: Ethernet 'uname -m' returns with armv7l os-release.txt I have run another OH4 instance on the same network on a Rpi4
Thanks for your kind support /