Question on SET - GET and Command poll.

apella12 commented 6 months ago

I have found this polling sequence in several forum debug logs and am not sure if this is how it is supposed to work. Could you clarify (if you get a chance)

OH Version: 4.0.4 thermostat-set-setpoint-fail.log what is happening 1) Set command is sent 2) Get command in 32 ms (right after Set command is finished) 3) Command Poll at 1500 ms polls every channel (Basically a "refresh")

No real harm except a lot of traffic. Also I thought the command poll delay was to allow time for a slow device to get to the SET state.

(Note the actual problem for the OP in the forum was that the SET command was not 'sticking', but my question is on the GET and command poll of all the channels)

openhab-bot commented 6 months ago

This issue has been mentioned on openHAB Community. There might be relevant details there:

https://community.openhab.org/t/zwave-polling-unlinked-channels/152554/2

apella12 commented 6 months ago

Ran detailed test on my own system and it works as expected

openhab / org.openhab.binding.zwave

Question on SET - GET and Command poll. #1904