Facility chart and table to differentiate source and load power/energy - Githubissues

opennem / opennem-fe

An Open Platform for National Electricity Market Data

https://opennem.org.au

MIT License

63 stars 11 forks source link

Facility chart and table to differentiate source and load power/energy #124

Closed chienleng closed 2 years ago

chienleng commented 2 years ago

Have total reg cap for source and load and add both reg cap lines in power chart. (this should affect the 'Card' component in map view too)
If there are 'load' units, values should be split up to show both source and load values with updated Total label
Proportion, Cap factor and Av. calculation should take that into account

For example:

https://opennem.org.au/facility/au/NEM/HORNSDPR/?range=3d&interval=30m	Unit	Registered Cap.	Energy	Proportion	Cap.factor
HPRG1 — Battery (Discharging)	150	449	{use source total}%	{use source total}%
HPRL1 — Battery (Charging)	150	691	{use load total}%	{use load total}%
Total (Discharging/Charging)	150/150	449/691		Av. x%/y%

https://opennem.org.au/facility/au/NEM/KENNEDY/?range=3d&interval=30m	Unit	Registered Cap.	Energy	Proportion	Cap.factor
KEPBG1 — Battery (Discharging)	2	8.8	{use source total}%	{use source total}%
KEPBL1 — Battery (Charging)	2	—	{use load total}%	{use load total}%
KEPSF1 — Solar (Utility)	15	310	{use source total}%	{use source total}%
KEPWF1 — Wind	43.2	958	{use source total}%	{use source total}%
Total (Discharging, Solar (Utility), Wind/Charging)	60.2/2	1278/—		Av. x%/y%

simonhac commented 2 years ago

when there’s a load fuel-type and the y-axis is power, please show two registered capacity lines — one for sources above x-axis, and one for loads below the x-axis.