Closed purvisb closed 2 years ago
I don't have a j-link device, and I'm not sure where to find the DUTserial for hwconfig.ini. Are either of those two missing requirements causing this issue? Or is there something else im missing? I don't see anywhere to define a port. I do see clusters.conf but I'm not sure what to put for the port in that.
The nRF52840 DK includes an onboard SEGGER J-Link debugger.
You can use J-Link Commander's ShowEmuList command to discover the serial number of an attached J-Link device.
I have an nRF52840 MDK. I don't believe this has an onboard SEGGER J-Link debugger. Let me know if the mdk model does have that.
Are there any other options available for me?
I have an nRF52840 MDK. I don't believe this has an onboard SEGGER J-Link debugger. Let me know if the mdk model does have that.
Are there any other options available for me?
Silk currently requires the SEGGER J-Link debugger.
Understood, Thanks!
Following this codelab.
On page 6 the instructions are sparse. I got a test to run but I'm getting an EM copied below.
I don't have a j-link device, and I'm not sure where to find the DUTserial for hwconfig.ini. Are either of those two missing requirements causing this issue? Or is there something else im missing? I don't see anywhere to define a port. I do see clusters.conf but I'm not sure what to put for the port in that.