8bitdo SN30 pro BT controller
Batocera v38 2023/12/9
switch updater last run 2023/14/9
Prior to running the Switch updater my controller was working as expected. After running the update, my controller no longer works in-game (except hotkey+start to exit).
I have tried yuzu & yuzu-early-access, keeping auto controller config set to auto and experience the same results with both.
If I go to yuzu-config > emulation > configure > controls and change the input device from any to xbox 360 controller 0 all the buttons presses are recognized.
If I then choose ok and launch a game from within yuzu-config, my controller works fine. If I then exit yuzu-config and go back to ES launching a game with auto controller config set to off, my controller is working fine. Setting auto controller config to auto causes the controller not to work again.
8bitdo SN30 pro BT controller Batocera v38 2023/12/9 switch updater last run 2023/14/9
Prior to running the Switch updater my controller was working as expected. After running the update, my controller no longer works in-game (except hotkey+start to exit).
I have tried yuzu & yuzu-early-access, keeping
auto controller config
set toauto
and experience the same results with both.If I go to
yuzu-config > emulation > configure > controls
and change theinput device
fromany
toxbox 360 controller 0
all the buttons presses are recognized. If I then chooseok
and launch a game from withinyuzu-config
, my controller works fine. If I then exityuzu-confi
g and go back to ES launching a game withauto controller config
set tooff
, my controller is working fine. Settingauto controller config
toauto
causes the controller not to work again.yuzu
logs
with control cfg set to auto & off are attached. auto-cfg controller - yuzu mainline.zip auto-config controller OFF yuzu mainline.zip