Open maydanshahi opened 3 years ago
Hey did you ever figure this out? I am facing a similar issue.
Hi Not yet
On Tue, Apr 13, 2021, 4:23 AM gallagherk17 @.***> wrote:
Hey did you ever figure this out? I am facing a similar issue.
— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/pachterlab/poseidon/issues/33#issuecomment-818316900, or unsubscribe https://github.com/notifications/unsubscribe-auth/ARI3VCARS42M46DCIDB5NHTTIOBWVANCNFSM4SGLQKMA .
Is you resolve that issue then plz guide me
Command was not sent to motor plz guide
I have followed all structures but The commands were not sent to stepper motors; however, the board connected to the gui controller successfully. I validated the arduino uno, cnc shield and stepper motors with another firmware (grbl) and every thing was okay. The commands sent to the board and then stepper motors successfully but when I use the poseidon structures, I faced to this problem. The controller was connected to board successfully, and the commands were sent to the arduino board correctly, but the stepper motors were not work. What should I do? could anyone help me?