Something is wildly wrong with the liquid sensor measurement on the software side. Every time I press 'update liquid levels', I get a random selection of dispensers lighting up as low, out or, good. In the liquid level tab, pressing the save threshold button confirms that the numbers are all over the place, between 50 and 200 typically. This is true on both v3 and v2 dispensers. I've looked at the output of the hardware, and it's rock solid, so I don't know if we're just looking at the wrong analog pin, or what.
Something is wildly wrong with the liquid sensor measurement on the software side. Every time I press 'update liquid levels', I get a random selection of dispensers lighting up as low, out or, good. In the liquid level tab, pressing the save threshold button confirms that the numbers are all over the place, between 50 and 200 typically. This is true on both v3 and v2 dispensers. I've looked at the output of the hardware, and it's rock solid, so I don't know if we're just looking at the wrong analog pin, or what.