I have two USB 2.0 Drives that only draw a max of 100mAH after using USB Deview to test the power they were using. They are both Micro SD Card Reader 2.0 USBs because I heard they require less power. I formatted both of them to FAT32 and named them SONY like the tutorials said.
I did extract Bleemsync 1.1 on both of them to try and did remove the power cord before plugging them into slot 2 (and tried 1). But upon boot up nothing happens. Are they still using too much power?
I don't know what I am doing wrong to be honest.
Also I did order an OTG cable and might order an externally powered USB hub or another USB 2.0 with no Micro SD reader if I have to.
Otherwise I'm guessing the resistor chips will need to be soldered?
I have two USB 2.0 Drives that only draw a max of 100mAH after using USB Deview to test the power they were using. They are both Micro SD Card Reader 2.0 USBs because I heard they require less power. I formatted both of them to FAT32 and named them SONY like the tutorials said. I did extract Bleemsync 1.1 on both of them to try and did remove the power cord before plugging them into slot 2 (and tried 1). But upon boot up nothing happens. Are they still using too much power?
I don't know what I am doing wrong to be honest.
Also I did order an OTG cable and might order an externally powered USB hub or another USB 2.0 with no Micro SD reader if I have to.
Otherwise I'm guessing the resistor chips will need to be soldered?