search

petrockblog / SNESDev-RPi

Simulates a virtual keyboard for two SNES controllers that are connected to the GPIO pins of the Raspberry Pi (TM)
52 stars 23 forks source link

connection issue #7

Closed aguirrech closed 11 years ago

aguirrech commented 12 years ago

Hi Florian, when i connect the Snes controller to Pi i get an unlimited serie de characters in the command line, It stops if i disconnect the controller. I installed your Snesdv trough the lastest RetroPie-Setup script, and all connections to GPIO ports seem to be ok.

Any ideas? How can i reconfigure or reinstall Snesdv cfg?

aguirrech commented 12 years ago

Snes controller is working well detected buttons et axes, tested with command " jstest/dev/ipunt/js0 " after installation "joystick", but there is always the characteres appearing in command line "iebtuc" repeated unlimited times.

aguirrech commented 12 years ago

i found the problem, is in the Snesdev autobooting option, if it is disabled all is working well

petrockblog commented 12 years ago

Thanks for the report! I will have a look at this tomorrow!

petrockblog commented 12 years ago

Did you install and run the the gamecon driver and SNESDev at the same time? I have observed that this also leads to an erroneous behavior.

petrockblog commented 11 years ago

SNESDev has received major updates and the game pads are note emulated as keyboard inputs anymore, but rather as joystick devices. I close this thread now and I ask you to open a new issue thread for possibly new connection issues.