Version 3.1

[samuk]

Is the new version still planned?

[krekr]

I’m watching this also. If the fix can be described, that would help as well. Thanks!

[samuk]

Yes that might help. @pgrady3 could you describe the problem?

[TinkerGear]

A description of the problem would be very helpful to us as well!

[pgrady3]

Hi all, apologies for the slow reply. I'm pretty busy here finishing up with my PhD, hence the slow progress. Adding a 22 ohm resistor between the transistor gate and the gate drivers fixes the problem of the gate drivers blowing up.

However, there were a few other issues that I've also been working on:

• The components are a bit too hard to solder, and determining the orientation of the SOT-23-6's is almost impossible. I'm switching them out for bigger components
• The code is a mess. It needs to be cleaned up and more thoroughly bug tested
• I think the gate driver deadtime is too short, and the transistors heat up a too much during operation.

Apologies on the buggy release. I rushed this one, and as a result it's not very polished.

[krekr]

Thanks very much. This gives me enough confidence to fork it and design a smaller version that fits into a certain application.

[samuk]

@krekr I'd be interested in checking out your fork if you could post it here.

[krekr]

Huzzah for v3.2! Thanks @pgrady3