search

phucktdt / eggbotcode

Automatically exported from code.google.com/p/eggbotcode
1 stars 0 forks source link

Manual Control panel (disable motors) doesn't notice changes caused by plotter... #8

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago 
Originally Reported by westfw, May 25 (4 days ago)
If you "disable motors" in the manual control panel, and then "Start" a
plot in the plotter panel, the motors will of course be enabled, but the
Manual Control panel will continue to lave the button label "Enable motors."

Since the "pen up"/"pen down" buttons are not "smart", I don't think the
motor enable needs to be either.  Just have two buttons...

Original issue reported on code.google.com by windell@oskay.net on 30 May 2010 at 11:46

GoogleCodeExporter commented 8 years ago 
So you would prefer to have two separate buttons, labeled "Enable motors" and 
"Disable motors?"

Even if so, it might be helpful if there were some way of indicating whether or 
not the motors are enabled, other 
than pushing one of the axes.

Original comment by windell@oskay.net on 3 Jun 2010 at 9:30

GoogleCodeExporter commented 8 years ago

Original comment by windell@oskay.net on 7 Jun 2010 at 1:22

GoogleCodeExporter commented 8 years ago

Original comment by windell@oskay.net on 7 Jun 2010 at 2:22

GoogleCodeExporter commented 8 years ago 
Separate enable and disable motor buttons added as of 6/6/10

Original comment by windell@oskay.net on 7 Jun 2010 at 8:47

GoogleCodeExporter commented 8 years ago

Original comment by windell@oskay.net on 7 Jun 2010 at 8:47