[x] Close the two valves to the drains of the steering area (in engine compartement)
[x] Close the valve for the coolant water intake (under filter)
[x] Open coolant water filter. Slowly pour one kettle full of boiling water onto its lid and then unscrew it
[x] Replace coolant water in engine with glycol (10L, pour into filter while engine is running, turn engine off immediately when bucket is empty)
[x] Pour some glycol in
[x] Drains in steering area
[x] Kitchen sink
[x] Toilet (pump a bit afterwards)
[x] Fix booms using boomscissors on the steering cabin roof
[x] Remove all loose ropes
[x] Raise booms and build roofing structure with slats of wood
[x] Cover boat in tarps
[x] Fix the heating fan with straps somewhere on the kitchen bench and connect it to a timer. Set it to lowest temperature (but still warming), and to run for 15mins every other 15mins.
[x] Install dehumidifier
[x] Ensure heating cable in bildge is connected
[x] Install the extra 220V bildge pump
[x] Verify functionality of all four bildge pumps and flotation switches
[x] Make sure the isolation transformer is directly connected to outside power, without a power board in between
[x] Check fenderts
[x] Check mooring ropes for damage
[ ] Call Annette when leaving so she knows that you're not on board any longer