search

pixhawk / Hardware

PX4 Hardware designs
1.05k stars 876 forks source link

wiring the console - where is GND? #1

Closed davidbuzz closed 10 years ago

davidbuzz commented 12 years ago

The wiring for the Serial/UART is shown on this page WITHOUT GND pins. https://pixhawk.ethz.ch/px4/users/apps/mavlink     On this page it's shown WITH GND pins. https://pixhawk.ethz.ch/px4/modules/wiring#other_setups

Unfortunately  the pic with GNS pins is hard to see where the wires go, but on the other pic it's clear where the RX/TX pins go, at least.

I had to check the https://pixhawk.ethz.ch/px4/modules/px4fmu#Connectors  page to be sure where the (black) GND pins went into the (black) connector.

Solution: need better close-ups of the wiring, especially the GND/s.

px4dev commented 12 years ago

Is the picture here: https://pixhawk.ethz.ch/px4/users/first_steps better?