Add the same granule to both the SIT (new) and UAT (old) environment on swodlr-ui
Apply all the filters for that single granule
Click apply
Parameters Used
cycle: 1
pass: 323
scene: 138
status: NEW
outputGranuleExtentFlag: 128 x 128
outputSamplingGridType: UTM
rasterResolution: 1000
utmZoneAdjust: -1
mgrsBandAdjust: -1
dateGenerated endDate: 06/21/2024 10:23 AM
dateGenerated startDate: 06/01/2024 12:00 AM
Results
SIT (new): 1.6 s with 163 total entries
UAT (old): 2.3 s with 49 total entries
Notes
My SIT has many more generated granules in the my data page table than my UAT does. This slows down the performance for the filters that are not yet using the endpoint (Status, Raster Resolution, UTM Zone Adjust, MGRS Band Adjust). SIT will be even faster when all filter properties are able to be used with the endpoint.
When looking at the screenshots of SIT and UAT, SIT has 1 total entry as the number and UAT has 49 total entries. This is because in the SIT (new) version I changed the total to show the number of entries currently being filtered as suggested by David Coleman.
Update SWODLR UI filtering page with new parameters that can be selectively enabled/disabled for additional filtering.