search

pomeroyb / PortalGun

Code to control a Portal Gun (From Rick and Morty)
32 stars 19 forks source link

Wiring Instructions #1

Open Hadr619 opened 8 years ago

Hadr619 commented 8 years ago

This is amazing but am fairly new to wiring and was wondering if you had a diagram of the wiring by chance

setiupyguppie commented 8 years ago

This might help: http://www.thingiverse.com/thing:1100601

pomeroyb commented 8 years ago

There's not really a diagram. All of the components are wired directly to the trinket, and those are listed in the readme as "Pin Definitions". So, for the LCD display, you would wire the display SCL directly to the trinket's A5, the display SDA directly to A4, etc.

The only somewhat tricky ones are the LEDs. One leg of the led is wired to a 150ohm resistor that's wired to ground, and the other leg is wired directly to the LED pins on the trinket. If you omit that resistor, you run the risk of burning out your LED.

setiupyguppie commented 8 years ago

For my own reference, I may be drawing up a schematic of sorts in the coming weeks. If I get it done (no promises!) I'll post a link here. :)

MrBelm commented 7 years ago

Did you ever draw up that rough schematic? I'm about to start building one.

reaghank commented 6 years ago

Portal Gun Schematic.pdf I've attached the schematic that I used when I made mine.