Open leebobleebob opened 2 weeks ago
Hi mayank785! Thanks for posting a helpful link, but I'm removing it for now since it's kind of sketchy. Could you explain more about what the program you linked actually does? If it's helpful to this I'll add the link back.
Wow fam Spot on! It was def the USB hub, I bet I need a powered one, I think I am just going to setup a separate Pi for the camera, this thing is flying now no issues!
Thank you so very much, Is there a place I can drop you a gift card for some coffee or something seriously, you fucking rock!
No place for that, sorry. But if you'd like, could you draft a section to explain how to flash firmware for https://github.com/printers-for-people/catboat/wiki/KIAUH-Install ? You can just write it here or in a new issue. That way people won't hit your other issue following those instructions. :)
I think I can manage that, give me a few days and I will see what I can manage! :)
Thanks! No hurry or rush. :)
On Mon, Aug 26, 2024 at 07:09:32PM -0700, leebobleebob wrote:
I think I can manage that, give me a few days and I will see what I can manage! :)
-- Reply to this email directly or view it on GitHub: https://github.com/printers-for-people/catboat/issues/43#issuecomment-2311431392 You are receiving this because you commented.
Message ID: @.***>
klippy-8.log.zip
Getting Error where Klipper shuts down randomly
Our previous convo located here:
https://github.com/printers-for-people/catboat/issues/31#issuecomment-2310870307
Lead you to think it is my USB Cable. I did recently get a USB hub to add a camera to Klipper, so I am now trying to print sans USB hub.
I did just grab the only USB A to B cable I could find at Microcenter so I will see how this goes, pretty expensive as always $20 Just like in the 90s lol.
I will update you on my findings :)