search

probatio / probatio-3dprinting

Probatio's models for 3D printing
Other
2 stars 1 forks source link

improvements in probatio_base_1x3_top_3mm_v7 #1

Closed jtragtenberg closed 4 years ago

jtragtenberg commented 4 years ago

IMG_5945 When I printed the 1x3 base's top part, there were two problems. 1) the filleted edges were deformed because the top of the model was facing down, on the 3d printer's base, it would be best to remove the fillets, make it a sharp edge like the bottom's or I should try to print with the top part facing up in the printer, with supports. 2) The corners the fit with the bottom part broke in half. It could be thicker or shorter... Or maybe could have a snap-fit solution like the blocks

jtragtenberg commented 4 years ago

It could be also because I used Octalapse: . I will try without time lapsing the print.

jtragtenberg commented 4 years ago

No need for an improvement, It was the Octalapse and a clogged nozzle that caused the issue IMG_3122