search

probonopd / WirelessPrinting

Print wirelessly from Cura, PrusaSlicer or Slic3r to your 3D printer connected to an ESP8266 or ESP32 module
352 stars 65 forks source link

Unable to connect with PrusaSlicer #138

Closed ghost closed 2 years ago

ghost commented 4 years ago

I get the error message:

Could not connect to OctoPrint: HTTP 404: Note: OctoPrint version at least 1.1.0 is required.

probonopd commented 4 years ago

Are you sure you have the correct address? It's been working for me. Which version of PrusaSlicer on which operating system?