protoloft / klipper_z_calibration

Klipper plugin for self-calibrating z-offset
GNU General Public License v3.0
1.06k stars 152 forks source link

Perform Auto Z at KAMP Center #137

Open Dylan144GT opened 8 months ago

Dylan144GT commented 8 months ago

Hi,

Is it possible to add a feature where the auto z is performed in the center of the KAMP zone rather than in the middle of the bed. This is because it is good practice to print in different areas of the bed to ensure even wear, but the variance of the bed may be different in different KAMP zones.

Personally I find I need to adjust the z-offset whenever I don't print in the middle of the bed. One can argue that I don't have a flat bed, but I don't think that I am the only one in this position, especially on the more budget printers.

Thanks,

Dylan

TitusLabs commented 5 months ago

Sorry, I don't use KAMP. But you can use the BED_POSITION parameter of the Z_CALIBRATION command. Would that be enough?