search

protoloft / klipper_z_calibration

Klipper plugin for self-calibrating z-offset
GNU General Public License v3.0
1.06k stars 152 forks source link

Offset is always outside the configured range #150

Closed gixxerfool closed 4 months ago

gixxerfool commented 4 months ago

DD7EAB1D-B72C-4AEA-B35D-3A7A89B08DB5 This popped up out of nowhere. Auto Z was working great every print, then all of a sudden it didn't. It has to retry the nozzle probe everytime, but still the offset is out of range. I found the heater block a little loose so I tightened that, ran probe_calibrate and still no change. This was all pre-update and updating did not seem to make any change. I am assuming the issue is in the toolhead since the second attempts for the nozzle is a direct correlation with the offset being out of range. I took the toolhead apart, made sure everything is tight and still no luck. Screenshot attached

gixxerfool commented 4 months ago

I think I found the problem, the hot end had trouble keeping a steady temp. I addressed that issue and it seems to have fixed this issue.