For some reason I decided to update my printer this weekend after leaving it be for 2 or 3 years. Once I finished I fixed some issues that resulted from changes to klipper that required config updates and then updated z_calibrate. Everything works fine up until the point that I try to run the z_calibrate macro. It will dock the klicky probe and test the z limit. Once its done I get this error:
Move out of range: 526.000 681.000 12.840 [0.000]
I can't seem to figure out where the coordinates are coming from as my machine is a voron 2.4 350mm. It does re-dock the probe before this error is thrown up on the screen.
Here is the part of the log when it happens:
For some reason I decided to update my printer this weekend after leaving it be for 2 or 3 years. Once I finished I fixed some issues that resulted from changes to klipper that required config updates and then updated z_calibrate. Everything works fine up until the point that I try to run the z_calibrate macro. It will dock the klicky probe and test the z limit. Once its done I get this error: Move out of range: 526.000 681.000 12.840 [0.000] I can't seem to figure out where the coordinates are coming from as my machine is a voron 2.4 350mm. It does re-dock the probe before this error is thrown up on the screen. Here is the part of the log when it happens: