protoloft / klipper_z_calibration

Klipper plugin for self-calibrating z-offset
GNU General Public License v3.0
1.06k stars 152 forks source link

Z offset not adjusting? #160

Open GTreaper opened 1 month ago

GTreaper commented 1 month ago

Been running auto z on my voron 2.4 for almost a full year now with close to 0 issues when suddenly the Z offset is to high. No worries tries to adjust, make sure nozzle is clean and so on Issue continues

So I do a calibrate_z and it gave me a new z position endstop so I changed that value to the new suggestion

Then i realized G0 z0. 1 is a bit to high. So I adjust the switch offset I adjust from 0.498 to 0.5, from 0.5 to 0.51 and this continues to 0.55 but still the distance between the bed and nozzle isn't 0.1 just slightly above. It doesn't feel like the offset is changing no matter what I do

I've tried adjusting the klicky probe, changed the clicky probe switch. The only thing I haven't tried changing is the whole Z endstop assembly.

So I'll happily take any suggestions on what the freak could possibly be the issue. I'm at a loss haven't had a single issue with it until now.

Thanks