search

protoloft / klipper_z_calibration

Klipper plugin for self-calibrating z-offset
GNU General Public License v3.0
1.05k stars 151 forks source link

Nozzle change alters docking height #49

Closed CorvusOculum closed 2 years ago

CorvusOculum commented 2 years ago

This is more of a question than an issue. The euclid probe docking height relies on the Z-endstop offset from the nozzle being probed. If I switch nozzles and the nozzle has a different length, this will mess up the docking height (the Z position the probe gets slid into the dock) Is there a way to temporarily home off of the switch body (which would always be the same) and use that offset for the docking then once stowed, home again off the nozzle?

TitusLabs commented 2 years ago

You can override the homing with your own macro and there you can use variables to set the position where to home. But, you need the probe already attached to do so...

I like to have my probe's dock at the bed too. But it's easier to attach it to the gantry - if it's possible with your printer.