search

prusa3d / MK3_Power_Panic

Other
33 stars 18 forks source link

Fix P8 pinout #8

Open tjhawkey opened 6 years ago

tjhawkey commented 6 years ago

It's not 1:1 with the einsy. Doesn't matter that much since the wires are soldered in, but it's still bad practice.

ok1hra commented 6 years ago

yes, but this is only temporary solution

boelle commented 6 years ago

what should it be in the end? i have the board open and have changed it to 2 pin molex kk connectors

image

i have only changed one of them as i need to move them and then move tracks and make sure everything will still pass check at board houses