There is no "setting" for ABS as a filament to change, load or unload within the Prusa Mini firmware. This is a little confusing and the temperatures which should be used for ASA and ABS also seem to be different as I have understood.
Can this profile can be added somehow to the firmware?
The problem got raised in the forum https://forum.prusaprinters.org/forum/hardware-firmware-and-software-help/abs-profile-on-mini
There is no "setting" for ABS as a filament to change, load or unload within the Prusa Mini firmware. This is a little confusing and the temperatures which should be used for ASA and ABS also seem to be different as I have understood.
Can this profile can be added somehow to the firmware?
Thanks