When print of first color is done there is color changing phase. When load of new filament/color is successful everything is ok but when load is not successful (eg extruder doesn't grab the filament) there is no chance to repeat load filament - just question if color is ok.
Is possible to improve it like:
1) print of first color
2) color change phase ->
a) auto unload filament -> was filament successfully unloaded? When "Y" then press continue to load new filament. When "N" then repeat this step "unload filament".
b) load filament -> was filament successfully loaded? When "Y" then purge and question if color is ok.... When "N" then repeat this step "filament loading".
Hi @Wolfram3D , you are in bad section. Your issue is related to Buddy firmware and this issue is solved in FW version 4.1.0-RC1, i'm closing this one.
When print of first color is done there is color changing phase. When load of new filament/color is successful everything is ok but when load is not successful (eg extruder doesn't grab the filament) there is no chance to repeat load filament - just question if color is ok.
Is possible to improve it like: 1) print of first color 2) color change phase -> a) auto unload filament -> was filament successfully unloaded? When "Y" then press continue to load new filament. When "N" then repeat this step "unload filament". b) load filament -> was filament successfully loaded? When "Y" then purge and question if color is ok.... When "N" then repeat this step "filament loading".
Thanks