Request pre heating 5-10sec to prevent failsafe in cold climates

prusa3d / Original-Prusa-MINI

Original Prusa MINI 3D printer hardware

https://www.prusa3d.com/original-prusa-mini/

GNU General Public License v3.0

428 stars 77 forks source link

Request pre heating 5-10sec to prevent failsafe in cold climates #38

Closed boobslappy closed 3 years ago

boobslappy commented 3 years ago

I am requesting adding a 5-10 preheat to raise thermistors above threshold for those of us with our printing in cold areas. I’m having to use a blow dryer and don’t see why it couldn’t heat for a bit before checking thermistors. Could this feature be added? I’m on a prusa mini+. Thanks.

TickTock- commented 3 years ago

Yes. Please! (or lower the threshold)

JohnnyDeer commented 3 years ago

Hi @boobslappy this requirement should be in Prusa-Firmware-Buddy repository, please open it there according to the templates. I´m closing this one here.