search

prusa3d / Prusa-Firmware-ESP32-Cam

Firmware for ESP32 Cam modules to be used in Prusa Connect
GNU General Public License v3.0
207 stars 20 forks source link

Snapshot fails to upload to PrusaConnect - 500 error in log #74

Closed ArtSpaziano closed 1 month ago

ArtSpaziano commented 1 month ago

Snapshot and stream look fine on prusa-esp32cam.local but snapshots fail to upload to PrusaConnect. Using 1.1.0 FullESP32-Cam-log.txt

Snippet of log entry:

024-10-04_01-59-32 - MCU Temperature: 56.11 *C 2024-10-04_01-59-35 - WiFi status: Wifi connected. SSID: Spazianos_2G, BSSID: A0:36:BC:82:5E:20, RSSI: -61 dBm, IP: 192.168.1.163, TX power: 19.5dBm 2024-10-04_01-59-35 - Taking photo... 2024-10-04_01-59-35 - The picture has been saved. Size: 2868 bytes, Photo resolution: 320 x 240 2024-10-04_01-59-35 - Photo OK! 0 2024-10-04_01-59-35 - Exif header OK! Len: 310 2024-10-04_01-59-35 - Start sending photo to prusaconnect 2024-10-04_01-59-35 - Sending Photo to PrusaConnect, 3158 bytes 2024-10-04_01-59-36 - Send done: 3158/3158 bytes 2024-10-04_01-59-37 - Upload done. Response code: Photo: 500 - unknown error code ,BA:Backend available 2024-10-04_01-59-37 - Save TimeLaps photo to SD card 2024-10-04_01-59-37 - Photo saved to SD card. EXIF

Plan on getting another ESP32 Cam to install 1.0.3 shortly to see if the problem goes away but it would be good to get this working, since it's the latest.

feyded1020 commented 1 month ago

Currently having the same issue, just started happening earlier today. Have tried to readd the camera, but still receive error 500.

ice987987 commented 1 month ago

same here

ArtSpaziano commented 1 month ago

It works this morning. It looks like bad timing on my part because I chose to put the camera into service on the same day Prusa was having problems with their server. All well now - closing this.