Prompt before updating firmware?

prusa3d / Prusa-Firmware-SL1

Original Prusa SL1 3D printer firmware

GNU General Public License v3.0

39 stars 17 forks source link

Prompt before updating firmware? #40

Closed malcinator closed 3 years ago

malcinator commented 3 years ago

Would it be possible in future to prompt before updating rather than just downloading the firmware and updating?

JakubSilar3D commented 3 years ago

Can you, pls describe, what happened in more detail and optionally provide the log? This seems to be a bug - in usual use cases there is no update without a prompt.

malcinator commented 3 years ago

Sure. I powered on my SL1 and when it connected to the network here it immediately downloaded the upgrade and installed it. I don’t remember being asked to proceed. I would revert to 1.5.0 and go back through the process but I’m now concerned that the firmware downgrade will brick the printer.

malcinator commented 3 years ago

Downgraded firmware. Powered off. Powered back on and notification to upgrade appeared. So no issue