Prusa-Support
commented
1 year ago Hello, thank you for your request! This was presented as a feature point to the development and hopefully, we can offer it in the near future. Depending on what your piece looks like, it's best to also add a small drainage hole close to the platform to release the pressure. I understand if this is no option for you, we will try to add more settings in the future.
murk-sy
xsoriginal
Is there a way we can edit the timings for the lift/retractions fully? Every cheap Chinese printer gives full control over speeds and timings and neither Faster, Slower or High-Viscosity are perfect for my resin. It would also be fantastic if we can disable tilt and use the new vertical lift motion from the high-viscosity profile instead to avoid warping on mechanical parts.
A bit more detail. My resin is viscous but the Slower profile is far slower than I need it to be. I'd like to be able to use the Faster profile but with a 1.0s wait time upon retraction. Without this, I experience serious blooming issues with my resin.
Is this something that can be changed in the firmware?