Closed adrienafl closed 2 weeks ago
Rolled back to 3.13.1, issue is gone
@adrienafl Just verified that it is working with 3.13.3 and previous versions. Do you have in OctoPrint -> Settings -> GCODE Scripts
M603
M601
M602
Only thing I have is : After print job is cancelled
; disable motors
M84
;disable all heaters
{% snippet 'disable_hotends' %}
{% snippet 'disable_bed' %}
;disable fan
M106 S0
How would I only have the issue with 3.13.3 and not 3.13.1 ? From what I've seen it looked like the printer wasn't taking in account my Z fin adjustment settings when starting a new print after one cancelled
I just observed this same behavior in 3.13.3 on my MK3S. First layer calibration looks good and runs correctly. As soon as I go to print It commands the nozzle high. The LCD said it was commanding a height of 0.4 instead of 0.2.
I tested with the print twice before resetting and it happened consistently. Hard resetting the printer via the button allows this to run correctly again.
I rolled back to 3.13.1 and issue is gone. I'll upgrade to MK3.5 soon so I didn't want to investigate furtger
This issue has been flagged as stale because it has been open for 60 days with no activity. The issue will be closed in 7 days unless someone removes the "stale" label or adds a comment.
This issue has been closed due to lack of recent activity. Please consider opening a new one if needed.
Printer type - MK3S Printer firmware version - 3.13.2
SD card or USB/Octoprint Octoprint
Describe the bug When starting a print just after cancelling one (from the printer), the printer prints too high which makes the first layer wrong. Mesh bed leveling looks good, the print head doesn't seem too high during this phase. This issue is gone after restarting the printer but comes back right after cancelling a print
To Reproduce
Expected behavior First layer should be right
Video Please attach a video. It usually helps to solve the problem.