As my previous feature request stated, I'm printing lots of PACF with 4 or more perimeter, and the size of small holes became off.
So I was forced to use OrcaSlicer to take adventage of this feature from it, but it's not as friendly to use as our native PrusaSlicer, and also a bit buggy with path generation.
But the feature does work and the option inner/outer/inner gave me not only good dimantional accrucy but also good surface finish, rather then the only option in PS (External perimeter first) gave me bad surface finish.
As my previous feature request stated, I'm printing lots of PACF with 4 or more perimeter, and the size of small holes became off.
So I was forced to use OrcaSlicer to take adventage of this feature from it, but it's not as friendly to use as our native PrusaSlicer, and also a bit buggy with path generation.
But the feature does work and the option inner/outer/inner gave me not only good dimantional accrucy but also good surface finish, rather then the only option in PS (External perimeter first) gave me bad surface finish.