How hard is it to add the variable heigh modifier to the SLA section of the slicer?
We at photonsters have developed a Resin Exposure finder that has been used by all community. This helps solve a important part of the equation on Variable Layer printing on SLA. since we can prin a card for each layer heigh and create profiles, then the slicer can adjust the exposures for smaller sections based on these resin profiles.
We also have a working command line OpenSlicer that use parameters from a txt file with the heights and exposures and slices the STL based on that could serve as inspiration.
Our work was based on Formlabs internal hackaton OpenSLASlicer and the Open Research they Called Varislicer made by Autodesk with their now defunct (and OpenSource) MSLA printer Ember.
feature request
How hard is it to add the variable heigh modifier to the SLA section of the slicer?
We at photonsters have developed a Resin Exposure finder that has been used by all community. This helps solve a important part of the equation on Variable Layer printing on SLA. since we can prin a card for each layer heigh and create profiles, then the slicer can adjust the exposures for smaller sections based on these resin profiles.
https://github.com/altLab/photon-resin-calibration
We also have a working command line OpenSlicer that use parameters from a txt file with the heights and exposures and slices the STL based on that could serve as inspiration.
https://github.com/Photonsters/Slicer/tree/v0.2-development
Our work was based on Formlabs internal hackaton OpenSLASlicer and the Open Research they Called Varislicer made by Autodesk with their now defunct (and OpenSource) MSLA printer Ember.
https://www.facebook.com/permalink.php?story_fbid=10157351582893680&id=651553679