3D printer brand / version + firmware version (if known)
Any
Behavior
I sometimes have prints where the draft-shield fails but the rest prints fine (except for the draft-shield extrusions which go all over the place).
I would like to be able to cancel the draft-shield in octoprint, this would require that the draft-shield is annotated like a separate part.
Adding @Object draftshield to the after layer change works as a workaround for now but I would prefer a cleaner solution
Version
Prusa slicer 2.2.0
Operating system type + version
Any
3D printer brand / version + firmware version (if known)
Any
Behavior
I sometimes have prints where the draft-shield fails but the rest prints fine (except for the draft-shield extrusions which go all over the place). I would like to be able to cancel the draft-shield in octoprint, this would require that the draft-shield is annotated like a separate part.
Adding
@Object draftshield
to the after layer change works as a workaround for now but I would prefer a cleaner solution