search

ptvoinfo / zigbee-configurable-firmware

PTVO firmware for CC2530, CC2531, and CC2652 Zigbee chips
https://ptvo.info/zigbee-configurable-firmware-features/
MIT License
192 stars 22 forks source link

Unable to configured correctly basic PSM CC2530 in z2m #256

Closed robotsflo closed 6 months ago

robotsflo commented 6 months ago

Hello,

I have a ploblem with my configuration below :

image image

This is very basic, but after flashing when the device is in paring mode, zigbee2mqtt report that : Capture

The device is still with (Z) logo with a warning red flag. (the logo can be 'DIY mobule' after success end-device mode but when I remove backup_coodinator file it go back to (Z) logo) The LED blink 1 to 4s, and after starting interview : still on OR turn off, I've had the two situations. I have test near coordinator, it's the same issue.

i have test the same conf with end device without routing and it work perfectly. It was been discovered and configured.

Z2M version : 1.34.0. PTVO firmware : 2023.12.12 Coordinator : CC2562P

robotsflo commented 6 months ago

The device that I use is SNZB-01, push button by SONOFF. And like the #198, I don't use the good option. Now 'without external Oscillator' all it's good =)