SwB Centers Channels 1-4

qba667 / FlySkyI6

14 channels FW modifications for FlySky I6

GNU General Public License v3.0

287 stars 72 forks source link

SwB Centers Channels 1-4 #108

Closed Thesciman closed 4 years ago

Thesciman commented 4 years ago

SwB is not configured to do anything, it has no mixes and throttle hold is not enabled. However, when I toggle it, immediately channels 1 through 4 are moved into the center, and moving the sticks has no effect. If I revert SwB to its original position, I can regain control and the sticks work as normal, moving their respective channels.

Yenya commented 4 years ago

It looks like SwB is configured for teacher/student switching. Go to System → Trainer mode, and check whether Mode is On and Switch is SwB, and the third line can be switched between Engaged and Not engaged using SwB.

If it is, you can just set Mode to Off. Remember to save the settings by leaving that menu with long holding the Cancel button.

Thesciman commented 4 years ago

I also had an issue where the rudder and elevator channels were not producing the full range of motion, even after re-calibrating the sticks many times. I was able to solve both these issues by doing a flash reset.

unitware commented 4 years ago

Double check that trainer/buddy mode isn’t enabled.

Skickat från min iPhone

23 juli 2020 kl. 18:53 skrev Thesciman notifications@github.com:

Closed #108.

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub, or unsubscribe.