PILA87 Firmware Flashing - Component Location

[rango886]

Issue Description

I recently purchased a PILA87 kit from Taobao and am preparing to flash the firmware. While reviewing the readme file at https://github.com/qmk/qmk_firmware/tree/master/keyboards/phage_studio/pila87, I noticed instructions regarding two electronic components that need to be soldered to the circuit board for flashing. Could you please clarify the location of these components on the PILA87 PCB? A diagram or photo highlighting their positions would be incredibly helpful. Thank you for your time and assistance.

[HorrorTroll]

Here you go, crystal is 4 pad and other 2 is capacitor. Try using multimeter to check which pad on crystal is OSC_IN and OSC_OUT before soldering.

[rango886]

Here you go, crystal is 4 pad and other 2 is capacitor. Try using multimeter to check which pad on crystal is OSC_IN and OSC_OUT before soldering.

Thank you very much, and I've noticed that firmware flashing with an ST-Link V2 utilizes a four-wire connection. Could you please clarify the proper connection of these four wires between the ST-Link V2 and the target PCB?

[HorrorTroll]

Thank you very much, and I've noticed that firmware flashing with an ST-Link V2 utilizes a four-wire connection. Could you please clarify the proper connection of these four wires between the ST-Link V2 and the target PCB?

Here the details:

• 1: N/A
• 2: N/A
• 3: GND
• 4: SWDIO
• 5: SWCLK
• 6: 3.3V (or 3V3)