search

qqzsxyz / iphodroid

Automatically exported from code.google.com/p/iphodroid
0 stars 0 forks source link

Openiboot console problem #29

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
What steps will reproduce the problem?
1.own a iPhone 2G
2.use iphodroid 0.6 R11
3.scroll mode

What is the expected output? What do you see instead?
Scroll mode come success but it stops at i2c: ack not received before byte 0. 
and no welcome to openiboot text

What version of the product are you using? On what operating system?
iphodroid 0.6 R11 iPhone 2G Mac OS X Leopard 10.5.2(vmware image)

Original issue reported on code.google.com by shivam.r...@gmail.com on 4 Jul 2010 at 5:17

GoogleCodeExporter commented 9 years ago 
Edit it was : Client connected: !<filename>[@<address>] to send a file, 
~<filename>[@<address>]:<len> to receive a file
--------------------------------------------------------------------------------
-------------------------
miu: epoch mismatch
PLL 1: off.
PLL 0: off.
PLL 1: 412000000
PLL 2: off.
PLL 3: 108000000
NOR vendor=bf, device=273f
syscfg: found version 0x00010001 with 8 entries using 184 of 8192 bytes
Successfully loaded bank1 nvram
Successfully loaded bank2 nvram
syrah_quiesce()
otf clock divisor: 5
fps set to: 59.976
SFN: 0x10300, Addr: 0xfd00000, Size: 0x14001e0, hspan: 0x280, QLEN: 0xa0
syrah_init() -- Hurray for displays
Syrah Panel ID (0x57d100):
   Build:          DVT7 
   Type:           SHARP 
   Project/Driver: M68/NSC-Merlot 
Writing LCD init registers...
Do init for Merlot
syrah_init success!
Installing gamma table 0x0000d100 / 0x0000ff70
camera: sensor model ID = 0x1580
menu: images loaded
USB state change: 0 -> 0
EP 0: 2
EP 1: 2
EP 2: 2
EP 3: 2
EP 4: 2
EP 5: 2
USB state change: 0 -> 1
usb: reset detected
USB state change: 1 -> 1
usb: reset detected
USB state change: 1 -> 1
radio: comm board detected.
USB state change: 1 -> 3
USB state change: 3 -> 4
radio: setting speed to 750000 baud.
radio: ready.
radio: enabling internal speaker
radio: internal speaker enabled
sdio: selecting voltage index 23
sdio: cccr version: 0, sdio version: 0, low-speed: 0, high-speed: 0, wide bus: 
1, multi-block: 1, functions: 1
sdio: turning off pull-up resistor on DAT[3]
Manufacturer ID: 0x2df, product ID: 0x9103
Function: 0, max block size: 256
Function: 1, max block size: 256, enable timeout: 1000 ms
sdio: Ready!
sdio: enabled function 1
wlan: ioport = 0x10000
wlan: firmware status = 0x0
multitouch: powering on
i2c: ack not received before byte 0
i2c: ack not received before byte 0

Original comment by shivam.r...@gmail.com on 4 Jul 2010 at 5:18