search

radandre / MATERIA101

A Marlin firmware for Materia101
36 stars 13 forks source link

Bearing holder files missing #1

Open kengdahl opened 9 years ago

kengdahl commented 9 years ago

Is there a possibility to a drawing or a model of the nylon bearing holders for the x-carrige?

This is a request we got on the Arduino Forum from a customer

radandre commented 9 years ago

Hi Kristoffer,You are in truth, I will upload the design of the bearing holder tomorrow. Thanks and Best regards Andrea  Da: Kristoffer Engdahl notifications@github.com A: radandre/MATERIA101 MATERIA101@noreply.github.com Inviato: Domenica 7 Dicembre 2014 18:09 Oggetto: [MATERIA101] Bearing holder files missing (#1)

Is there a possibility to a drawing or a model of the nylon bearing holders for the x-carrige?This is a request we got on the Arduino Forum from a customer— Reply to this email directly or view it on GitHub.

kengdahl commented 9 years ago

Thank you :)

radandre commented 9 years ago

Step files, do you think stl are better?

Andrea

Il giorno 09/dic/2014, alle ore 18:46, Kristoffer Engdahl notifications@github.com ha scritto:

Thank you :)

Are they "smaller step files" or sketchup files? .stp is used for booth formats.

— Reply to this email directly or view it on GitHub.

kengdahl commented 9 years ago

Well. since we use open source programs I ad some troubles opening the file in FreeCAD. I found out that it was a STEP file, but still I can't open it.

f you give me a STL file I can make a FreeCAD file from it.

kengdahl commented 9 years ago

An STL file suffice, but the original file from the program you used should be uploaded. Ideally there should be a openSCAD or FreeCAD file for the printer to be fully open source.