Attempted to use UART for communication for boards [Does not Work]

raf181 / Ghostkey

GNU General Public License v3.0

0 stars 1 forks source link

Attempted to use UART for communication for boards [Does not Work] #4

Closed raf181 closed 1 month ago

raf181 commented 1 month ago

Hardware Connections:

Power Connections Connect the 3.3V pin of the SAMD21 to the 3.3V pin of the ESP32C6. Connect the GND pin of the SAMD21 to the GND pin of the ESP32C6.
Communication Connections Connect the TX pin of the SAMD21 to the RX pin of the ESP32C6. Connect the RX pin of the SAMD21 to the TX pin of the ESP32C6

XIAO SAMD21          XIAO ESP32C6
   3.3V  ---------------->  3.3V
   GND   ---------------->  GND
   TX    ---------------->  RX
   RX    ---------------->  TX

[ ] Check if the C6 board can be powered by the SAMD21 Board

raf181 commented 1 month ago

Used I2C for communications, Breadboard prototype

XIAO ESP32C6

19:28:02.451 -> Connecting to WiFi ...
19:28:21.858 -> IP address: 192.168.0.35
19:28:21.858 -> Sent command: typ

XIAO SAMD21

19:28:21.857 -> Recived command:typ