Zamazenta
commented
2 years ago Going to close this- as it seems the issue was in fact just me being stupid. Seems that the spot I put my gbs blocks the signal... Oops! Moved it to a better location and it seemingly works fine now. It is a bit weird that it only halpened when a signal was present, but oh well, its working now.
I've compiled & flashed the latest firmware and everything seems to work properly, except the web ui. When no video signal is present, I am able to access the web ui just fine. Once a system is turned on (in this case a PS2 using component), the web ui immediately begins showing a flashing red icon, and settings are unable to be changed. This happens on both my phone and PC. Neither devices lose connection to the access point in this state, they are just unable to use the web ui. Turning off the system and waiting a few minutes will make the web ui functional again, although it seems like I can't change any settings in this state.
I have been able to get it to load a few times and stay connected for at least long enough to test one or two different settings. Every setting I was able to try worked, its just that I can almost never access them.
I've already tried turning off mobile data on my phone as some others have suggested in similar issues, but that did not do anything. Right now my PS2 is the only system I actually have a video cable for that can connect to the gbs, although I have purchased a SNES cable that should arrive this week if you want me to try using a different system.
Should also note that this is a prebuilt GBS from chipnetics, however I doubt the issue is anything related to the build? Perhaps its an issue with my compilation of the firmware.
Hopefully I am not missing something stupid here.