I am trying to get my AV signal into the GBSC. I have a AV to VGA converter that works, tested it and it has a signal out on my monitor.
When I connect it to GBSC it doesn't do anything. But when I remove the 100 Ohm resistor it works, but it does not want to be set to anything, it always resets to Pass Through (If 100ohm is removed), so when I put back the 100 ohm resistor it has no picture. So the device works because Pass Through shows a picture. Is there something wrong? Am I doing it wrong?
Thanks for the reply
Edit: Here is some LOG stuff when the 100 ohm resistor is connected:
Source format not properly recognized, using fallback preset!
<reset>
Activity detected, input: RGB
VSync: present
HSync: presentRGB/HV
user command s at settings source 5, custom slot 65, status 22
Source format not properly recognized, using fallback preset!
<reset>
First of all many many thanks for GBSC!
I am trying to get my AV signal into the GBSC. I have a AV to VGA converter that works, tested it and it has a signal out on my monitor. When I connect it to GBSC it doesn't do anything. But when I remove the 100 Ohm resistor it works, but it does not want to be set to anything, it always resets to Pass Through (If 100ohm is removed), so when I put back the 100 ohm resistor it has no picture. So the device works because Pass Through shows a picture. Is there something wrong? Am I doing it wrong?
Thanks for the reply
Edit: Here is some LOG stuff when the 100 ohm resistor is connected: