The issue is the video sync goes into a reset loop, and video is only present for a few seconds
I noticed if I stop syncwatcher under debug after the adapter finds sync the video blanking stops.
DEBUG MESSAGES
Scanning inputs for sources ...
Activity detected, input: RGB
VSync: present
HSync: presentRGB/HV
RGB/HV upscale mode
ADC offset: R:46 G:43 B:42
Active FrameTime Lock enabled, disable if display unstable or stays blank! Method: 0 (vtotal + VSST)
preset applied: 1920x1080 for scaling RGB (HV Sync)(set your TV aspect ratio to 16:9!)
Note: scaling RGB is still in development
RGB/HV < > SOG
I think this can be closed, I used a new gbs-8200 board and re-did all my cable leads (made as short as possible) and I'm not seeing the reset loop with Syncwatcher enabled now!!
The issue is the video sync goes into a reset loop, and video is only present for a few seconds I noticed if I stop syncwatcher under debug after the adapter finds sync the video blanking stops.
DEBUG MESSAGES