Open fopinski opened 3 years ago
The only thing that helps running the 32 bit version is using arm_64bit=1 in /boot/config.txt But that would be kind of far away from the goal of running a 32 system :-)
I installed 5.10 to get the referenced driver but still no USB working:
Linux raspberrypi 5.10.0-rc6-v7l+ #1 SMP Fri Dec 4 20:52:04 CET 2020 armv7l GNU/Linux
Describe the bug Raspberry Pi 4 Modell 4GB USB Ports suspended with RPI OS 32. Ports can't be activated.
To reproduce Install latest image of Raspberry Pi OS 32 (2020-08-20-raspios-buster-armhf) with Raspberry Imager.
Expected behaviour USB hardware attached to the ports should get recognized.
Actual behaviour USB hardware attached to the ports are not recognized as ports are suspended.
System Raspberry Pi 4 Modell B 4GB
raspinfo.txt
Logs and Additional context
Thread in forum https://www.raspberrypi.org/forums/viewtopic.php?f=28&t=291752
Here is the summary of what I did with a lot to read with logs and everything that could be interessting:
The USB ports are basically working with
But not working with
OS used
Chronological order and logs Sorry I did not know about raspinfo before I tried to open an issue here.
interessting part from dmesg
complete dmesg dmesg1.txt
The I did a sudo apt update, sudo full-upgrade
Issue still persists. Some info regarding usb
I installed uhubctl (https://github.com/mvp/uhubctl) and tried to activate port 1
dmesg tells me the following after the command is finished
I executed rpi-update (sure, why not...)
Issue still persists.
2. Ubuntu 64 installed with Noobs No logs saved but same usb error messages as in Raspberry Pi OS 32.
3. Raspberry Pi OS 32 installed with Raspberry Imager (can't recall if it was the image from May or August) No logs saved but same usb error messages as before.
4. Raspberry Pi OS 64 installed with Raspberry Imager (2020-08-20-raspios-buster-arm64) Stock version from image, no update etc. No logs saved but there where no usb errors, usb was working fine!
5. Raspberry Pi OS 32 installed with Raspberry Imager (still can't recall if it was the image from May or August) No logs saved but same usb error messages as before...
I was told in the official forum to install the 64 version again and run another full upgrade and then switch back to 32 and check if it's ok.
6. Raspberry Pi OS 64 installed with Raspberry Imager (2020-08-20-raspios-buster-arm64)
I updated it with apt update and apt full-upgrade
dmesg2.txt
Then I swapped the cards
7. Raspberry Pi OS 32 installed with Raspberry Imager (2020-08-20-raspios-buster-armhf)
dmesg3.txt
After a full-upgrade also still not working
dmesg4.txt
Still not working.
FWIW dmesg from Noobs (in addition a usb drive was attached and correctly recognised) dmesg5.txt