Security+ 1.0 state not syncing

ratgdo / homekit-ratgdo

A native HomeKit implementation of a Security+ 2.0 garage door controller based on ratgdo hardware

https://ratgdo.github.io/homekit-ratgdo/

GNU General Public License v3.0

214 stars 21 forks source link

Security+ 1.0 state not syncing #159

Closed crockpotveggies closed 3 months ago

crockpotveggies commented 6 months ago

Purple square learn button. Ran MQTT firmware for 3 months stable. Switched to HomeKit firmware. Haven't rewired.

After switching door protocol in settings, the only function I'm able to perform is close the garage door. However the state remains on. Additionally, the light switch is not updating and remains off and I'm unable to control it.

Edit: strangely when I leave it alone, it still thinks the Garage is open and when I try to close it, it then opens the already closed garage door.

I don't see any prompts to view logs, so I assume there's no crash? How do I debug this?

jgstroud commented 6 months ago

So this is a security+ 1.0 door. maybe @mitchjs knows what might be going on?

jgstroud commented 6 months ago

Also, in the current build, the logs are only available in the serial console.

crockpotveggies commented 6 months ago

@jgstroud is there a link or wiki page that describes how to set up the serial console?

mitchjs commented 6 months ago

@crockpotveggies, Do you have a wall panel? if not it has to go in to emulation mode.... not as well tested, as 99% of the people got a wall panel (and not a plain old push button)

100ideas commented 5 months ago

Just shared my similar issues with console logs over at https://github.com/ratgdo/homekit-ratgdo/issues/132#issuecomment-2165326762

mitchjs commented 4 months ago

good news, i found the issue (my fault)... i will fix with a PR soon

dkerr64 commented 3 months ago

Fixed in version 1.6.1