Closed EasyIP2023 closed 3 years ago
Hi @EasyIP2023,
Which Yocto/OE release and respectively branch of meta-rauc-community
are you using?
Keep in mind that the project has evolved since I wrote the article and numerous community contributions have been merged in master
and honestly due to lack of enough time for testing they may resulted in certain issues.
Thanks, Leon
@leon-anavi no worries. Thanks for writing that! I was on Yocto/OE (Dunfell 3.1.8) when I was first testing later switched to (Dunfell 3.1.10). Also on the latest commit of meta-rauc-community branch dunfell. Will first try to switch to branch master. If that doesn't work revert to a later meta-rauc-community (branch master) commit maybe one from before Sept 2020.
Hi @EasyIP2023,
Sounds as a good plan. If you are using Yocto/OE release Dunfell 3.1.8 I would recommend using the dunfell
branch. There were some recent syntax changes in master
which are not compatible with dunfell
, for example GitHub pull requests https://github.com/rauc/meta-rauc-community/pull/20 and https://github.com/rauc/meta-rauc-community/pull/19.
Please provide feedback of your finding as it will be useful for the community and fixing these issues.
Thanks, Leon
@leon-anavi Closing issue as after some investigation the problem isn't with the meta-rauc-community/meta-rauc-raspberrypi layer, but with u-boot support for the raspberrypi 4B. Seems like it doesn't want to work with the latest raspberrypi bootloader/firmwar.
U-Boot 2021.10-rc3-dirty (Sep 05 2021 - 15:23:39 -0500)
DRAM: 3.9 GiB
RPI 4 Model B (0xc03112)
mbox: Timeout waiting for response
bcm2835: Could not set module 3 power state
initcall sequence 000000003b3d28f8 failed at call 0000000000084344 (err=-5)
Here's a link to something similar years ago. Implemented by agherzan.
I decided to try the compile u-boot from source and try it on the latest raspberry pi stock image. Ran into similar results. Which leads me to believe. u-boot isn't configured to work with the latest raspberrypi bootloader/firmware. At least from what I am seeing.
Thank you for the feedback and the provided details.
Best regards, Leon
I cant seem to get the PI to boot with A/B dual partition + rauc. I've followed this tutorial here https://www.konsulko.com/getting-started-with-rauc-on-raspberry-pi-2/, but no matter what I do I always see the bellow error. Even setting
kernel=uImage
inconfig.txt
and settingKERNEL_IMAGETYPE = "uImage"
yields the same results.