search

rawk-v / minimosd-extra

Automatically exported from code.google.com/p/minimosd-extra
0 stars 0 forks source link

firmware update fails, lost sync. #123

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
What steps will reproduce the problem?
1. I connect minimosd to usb via FTDI DT232RL chip 
2. Open MinimOSD-Extra_R800 > OSD_Config.exe
3. Options > Update Firmware > MinimOsd_Extra_Copter_R800.hex (plane does the 
same)
4. Sometimes update gest to 40%, sometimes 16%, sometimes 5%. Everytime it 
stops, and says "Upload failed. Lost sync. Try using arduino instead."
5. Trying to Read from OSD says "EEPROM mapping is outdated."
6. I have also tried updating bootloader with arduino/usbasp and it seems to 
update, but it doesnt help with the problem.

What is the expected output? What do you see instead?
I'd like to see a working minimosd but never seen one. Is it an unicorn?

What version of the product are you using? On what operating system?
MinimOSD-Extra_R800
Windows 7 64bit
MinimOSD: 
http://www.ebay.com/itm/271718396329?_trksid=p2059210.m2749.l2649&ssPageName=STR
K%3AMEBIDX%3AIT
FTDI USB: 
http://www.ebay.com/itm/271770639074?_trksid=p2059210.m2749.l2649&ssPageName=STR
K%3AMEBIDX%3AIT

between minim and ftdi I have 5 pins connected > 
GND to GND
RX to TX
TX to RX
5v to Vcc
DTR to GRN. 

Also tried straight 6pin connection with even worse results.

Original issue reported on code.google.com by jussi.hi...@gmail.com on 17 Mar 2015 at 11:12

GoogleCodeExporter commented 9 years ago 
Had the same problem.
I swap the FTDI CTS with the GND and solved the problem! so it is:

FTDI to mimOSD

GND  to BLK
CTS  to GND
VCC  to +5V
TXD  to RX
RXD  to TX
RTS  to CRN

Hope it helps

Original comment by manthosg...@gmail.com on 17 Mar 2015 at 9:18

GoogleCodeExporter commented 9 years ago 
As I wrote there already, also tried straight 6pin connection with even worse 
results.

Original comment by jussi.hi...@gmail.com on 17 Mar 2015 at 9:44

GoogleCodeExporter commented 9 years ago 
I attached 2 photos to demonstrate how I have tried connecting these. Neither 
way works.

Original comment by jussi.hi...@gmail.com on 17 Mar 2015 at 9:57

Attachments: